This weekend it was time to put antifouling paint to the bottom of the boat. It wasn’t too warm but adding some thinner helped the job.
While the paint dried I decided to try some waxing. It went pretty well but I managed to wax some fresh antifouling paint in the waterline and it was a pain in the ass to clean. But the end result worth the sweat, it turned out beautiful! The boat looks like new.
Speaking of pain in the ass. I also decided to change the old anchor light. It could have been fixed with a drop of crc and tape, but that would have been to simple.
I checked that this is an easy job with just unscrewing of two screws and putting a new light replacing the old worn one.
Ok, first screw was pretty easy. Some crc and force to open the screw which was stainless steel from the aluminum masthead.
Second screw was a #%***#! It snapped apart from the base without leaving any screw to open it with pliers or anything. After some bad language and thinking I decided to drill a new hole in the middle of the old snapped screw. I actually didn’t believe that would work but apparently I had some skills or good luck and I managed to make a new hole for the screw.
Of course I also had to measure and cut two new screws because the first old screw was bent and second was snapped.